Vinotheque Wine Cellars Owner's Manual Page 23

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 22
Customer Service - 1.800.343.9463 Page 20
TROUBLESHOOTING CONT.
Door gasket not sealing correctly
If the cabinets cooling system is running continually without reaching the
desired temperature, the problem may lie with the door gaskets not seal-
ing correctly.
Examine the door gasket around the entire unit.
You can also check this by turning on the cabinets interior light and turn-
ing o the lighting in the room. Determine if there is an area that is not
sealing properly.
If a problem exists, use the following guidelines to resolve
the problem:
• Heat up the gasket with a hair dryer while using your
ngers to pull the gasket outward, using caution while
the gaskets may be hot. Doing this for several minutes will
loosen the gasket material and increase its exibility.
• Close the door and determine if the magnetic strip within
the gasket will seal with the metal strip on the door.
• Repeat steps until gasket seals correctly. Once it has reseat-
ed itself, leave the doors closed for two to three hours. The
seal should retain the new shape after this process.
Door realignment
The door can be adjusted by loosening the three Allen head
bolts (easier done from the outside), securing the top and bot-
tom pivot hinges through slotted mounting holes and moving
the hinge(s) in the appropriate direction. Re-tighten the bolts
after the adjustment is completed only after checking the level
of the cabinet.
How to correct a warped door
Leave the door open to expose both door surfaces to the same
outside condition for 24 to 48 hours. To accelerate the process,
wet the contracted (dry) door panel with a damp towel or
sponge and allow drying with both door sides exposed.
How to prevent future warpage
Thoroughly seal both sides of a straight door with two coats of
high quality moisture proof wood sealant to prevent any further moisture exchange.
Never seal a warped door, as it might be impossible to correct the condition after treatment. Vi-
nothèque is not responsible for reversible moisture induced warpage of unnished doors or for door
stained, and/or sealed after shipment from the factory.
Unnished wood cabinets are NOT warranted against warpage
door adjust.allen wrench
Page view 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Comments to this Manuals

No comments