Customer Service - 1.800.343.9463 Page 2
Cabinet installation is a very simple process, spending a small amount of time ne tuning the cabinet
will ensure cabinet aesthetics and longevity.
These are the simple steps for installation (further explained on the indicated pages):
1. Inspect the cabinet (below)
2. Unpack the cabinet and clean up the debris
3. Place the cabinet in a suitable location in your home (below)
4. Level the cabinet (pg. 4)
5. On QT Series, remove the protective panel from the rear of the cabinet (do not remove the
panel on front venting cabinets)
6. Adjust the doors (pg. 5)
7. Attach the door handles
TRANSPORTATION OF CABINET
When the cabinet arrives, inspect the unit to make sure that no damage has occurred during shipping.
Look for any marks, tears or damage, which might aect the cabinet. If you notice any damage,
remove the packaging and see if the unit was aected in any way.
On QT Series cabinets, specically inspect the compressor pan, located at the bottom rear of the unit.
Note if any oil has leaked into the pan.
In the event that damage has occurred, you need to write the extent of the damage on the original
shipping document, which is called Bill of Lading. The Original Bill of Lading will then be used to le a
freight claim. Immediately notify Vinothèque or your distributor to le a claim. You can accept or deny
the delivery if the unit is damaged. Any damage must be noted by yourself and the installation crew
on the Original Bill of Lading, which you both will be required to sign.
Based on the extent of the damage, the cabinet may be returned to the factory and repaired or
replaced. For minor scratches, the moving company will send a qualied furniture repair company
representative for touch-up work.
INSPECTING YOUR CABINET
FREIGHT DAMAGE
Comments to this Manuals